Pettit Racing RX-8 Forced Induction System 

Highlights:
- 60-100 additional horsepower and torque with only 5-8 psi boost
- Superb drivability and overall performance
- Reliable and easy to maintain
- D.I.Y. installation, with easy to follow instructions
- Only the highest quality components
- More Info Click Here

Stage II 275 WHP & 185 lb/ft*

………………………………..$5995

Stage II CS 300 WHP & 195 lb/ft*

………………………………..$6395

PCM-FI recal kit …………… $995

For D.I.Y installs our kit has everything necessary to install the PCM-FI recal file; however, Internet connection is required.

$500.00 Deposit for Stage II

$500.00 Deposit for Stage II CS

To reserve an FI kit from our next production run, a $500 deposit may be placed. These FI kits are expected to ship in Feb and March 09. Deposits can be placed either by phone or by clicking one of the links above.

For shipping charges please provide phone # and complete shipping address, we cannot ship to a PO box, email to shipping@pettitracing.com

A complete install at our facility is $995 and usually completed in 3-4 days, an appointment is required, call or email info@pettitracing.com

 All parts can also be purchased separately.

Complete Installation at our shop is $995 plus tax. Call now to schedule 561-844-2258!

-Pettit FI Info (DOC)

Pettit Racing Billet Bypass Valve
Pettit's new billet bypass  valve is designed to replace the original plastic part on our rx8 Forced Induction kit. This hi-flow design utilizes dual o-ring’s to seal the piston. (No diaphragm to fail) Finished in black hard anodizing. Lifetime Warranty.
Price: $149.99

Turbo Cover
The Thermal Barrier Cover is designed to fit around the turbo hot section, made from advanced thermal material, reinforced with inconel wire, and secured with stainless steel staples, providing a very durable and long lasting part. Fits most turbos.
Price: $159.00

Heat Shield
A stainless steel heat shield, designed for Mazda 13b engines, fits between the lower intake and the turbo system It’s job is to block radiant heat absorption into the lower intake manifold reducing charge air temperatures and increasing horsepower. The shield can also be layered with thermal barrier panel material, further improving heat rejection. This design retains an air space between lower intake and shield, further reducing heat transfer.
Price: $69.00

Thermal Barrier Panel Sections   2’x 2’
The Thermal Barrier Panel or “TBP” is made from non-woven thermal insulation and is created specifically for use in areas where minimum space is available. Pressure sensitive backing for easy install.
Price: $49.00

Thermal Barrier Wrap

3” wide 20’, 40’ and 100’ foot rolls. The Thermal Barrier Wrap or “TBW” is made of woven thermal insulation, and is used to wrap exhaust tubes, down pipes etc.

$1.75/ft under 100ft. $1.55 over 100ft

Price: $34.99 /20ft

Price: $69.99/40ft    

Price: $154.99/100ft

Metal Thermal Tape
Used for sealing the edges of TB Panels
Price: $.65/ft